Reloading Die by Bullet Central (6mm PPC,6mm Dasher, or .308)

Reloading Die by Bullet Central (6mm PPC,6mm Dasher, or .308)

5.00 out of 5 based on 1 customer rating
1 customer review

$250.00

Caliber :
Clear selection

Reloading Sizing Die, Bullet Central,

  • Gives the shooter complete control over where the case is sized and how much.
  • Provide the right amount of sizing on the base and shoulder for benchrest competitive shooting.
SKU: N/A Category:

Description

Sizing your cases is possibly one of the most overlooked activities in reloading for accuracy.This die will provide you with the correct amount of sizing at the shoulder and base of the 6PPC case and be very straight. We have a method for chambering these sizing dies that is unique and it results in a very straight sizing chamber. Each die is chambered to exacting standards and checked for runout. It is then sent out for Nitride or QPQ treatment to harden the surfaces. When it is returned it is checked again and cleaned up inside and out.

An improperly sized case can result in multiple issues. Other than simply running through brass more quickly you will run into poor chamber fit, hard bolt lift, “clicking”, case separation (more severe case), runout in loaded rounds, and so on. If your sized brass is not straight using our dies then you likely have a neck bushing that is out of round. This is a big contributing factor to out-of-round cartridges. Tony Boyer uses our sizing die. Tony is one of the most demanding shooters in the world, if he likes our die, we think you may too. If you need any assistance in how to setup your sizing die correctly, please give us a call. A good reloading sizing die used properly is possibly one of the most important aspects of target shooting.

Additional information

Caliber

6mm PPC, 6mm Dasher, .308

Brand

Bullet Central

1 review for Reloading Die by Bullet Central (6mm PPC,6mm Dasher, or .308)

  1. Rated 5 out of 5

    Chet Whitebread

    I bought one at the National’s and did as Chris said. Square up a correct size bushing and then check the sized case. The sized case’s now all have less then .0003 run out with most well under .0002. Very nice workmanship and finish. Best full length sizing die I have ever had. Thanks Chris
    Chet

Add a review

Your email address will not be published.

0 $0.00
Join Waitlist We will inform you when the product arrives in stock. Just leave your valid email address below.
Email Quantity We won't share your address with anybody else.